I stared at two giant rolls of shipping wrap in my garage after moving day. I wondered can bubble wrap be used as solar pool cover to warm our chilly water.
Real pool blankets cost two hundred dollars, while my leftover packing wrap was completely free. So I taped three sheets together and floated them on our water for two weeks.

Can Bubble Wrap Be Used as Solar Pool Cover in My Test?
Yes, standard packing bubble wrap warms pool water by five to seven degrees over a weekend. However, thin shipping plastic melts into tiny flakes within two weeks of sun and chlorine.
During my first three days, the clear shipping wrap worked much better than I expected. The small air pockets trapped daytime warmth and stopped night steam from escaping into the air.
My digital thermometer jumped from sixty-eight degrees on Friday to seventy-four degrees by Sunday afternoon. By day twelve, harsh July sunlight made the thin bubbles brittle and flaky in my skimmer.
My Biggest Backyard Lesson: Packing bubble wrap heats small pools well for a single weekend party. Leaving it on chlorinated water past ten days creates a messy filter jam.
| Option I Tried | Best Use Case | My Honest Verdict |
|---|---|---|
| Thin 3-mil packing wrap | Weekend heat for kiddie pools | Heats fast but flakes in weeks |
| Heavy 6-mil moving wrap | Two-week heat on small tubs | Holds up slightly better in wind |
| 12-mil blue solar cover | Full summer use on big pools | Lasts four years without flaking |
| Foil bubble insulation | None in sunny outdoor pools | Reflects sun and keeps water cold |
When Can Bubble Wrap Be Used as Solar Pool Cover Safely?
Packing bubble wrap only makes sense for temporary, unchlorinated kiddie pools that have no filter pump. Since there is no skimmer or motor, loose plastic flakes cannot jam expensive pool gear.
In four short setups, can bubble wrap be used as solar pool cover works fine:
- Weekend kiddie pools: Float one sheet on Friday morning to warm hose water for Saturday play.
- Small dog tubs: Warm up plastic pet pools on cool spring mornings in four hours.
- Stock tank tubs: Cut a circle of heavy wrap to hold heat overnight between dips.
- One-night freeze guard: Trap surface warmth overnight while waiting for a real pool cover delivery.
Why Packing Bubble Wrap Works at First Then Backfires
Shipping wrap traps heat because sealed air stops evaporation, but it lacks UV blockers for sunlight. Real solar covers use thick polyethylene resin mixed with sun shields and chlorine guards.
When warm water turns into night steam, it pulls massive heat out of your pool. Floating any airtight sheet over the surface stops ninety percent of that cooling loss immediately.
That explains why my garage wrap matched a real solar blanket during the first weekend. Then pool chemicals took over, and the thin shipping film rotted faster than wet paper.
What Surprised Me About Sun and Chlorine Damage
Standard shipping wrap is only 3 mils thick, while real pool covers measure 12 mils. In simple terms, one mil equals one thousandth of an inch of plastic thickness.
Without UV blockers baked into the film, harsh afternoon rays snap the thin plastic chains. Meanwhile, rising chlorine gas attacks the bottom of every air pocket touching the water.
| Common Advice | My Real-World Test | Better Move |
|---|---|---|
| Packing wrap is identical plastic | It is four times thinner | Buy UV-stabilized 12-mil pool film |
| Duct tape holds wet seams | Glue turned slimy in three days | Fuse seams or use vinyl tape |
| Large half-inch bubbles heat best | Tall bubbles caught wind and flipped | Use small 3/16-inch flat bubbles |
| Foil bubble wrap traps heat | Foil bounced sunlight into the sky | Use clear translucent plastic only |
Critical Safety Warning: Never use packing wrap around small kids or pets without watching them. Thin shipping film clings to wet skin and creates an instant trap hazard.
Here is how fast my clear packing wrap broke down on an eighty-degree pool:
- Days 1 to 4: Bubbles stayed plump, water gained six degrees, and edges held flat.
- Days 5 to 8: Tape seams turned gummy and peeled loose in the afternoon breeze.
- Days 9 to 12: Plastic turned cloudy white and popped loudly when I rolled it up.
- Days 13 to 14: Hundreds of tiny clear bubble caps tore loose and sank underwater.
How Long Can Bubble Wrap Be Used as Solar Pool Cover?
Standard packing bubble wrap lasts only ten to fourteen days in summer sun before shedding microplastics. When testing can bubble wrap be used as solar pool cover, follow strict time limits.
I used a caliper and water test kit to track why my sheets failed early. Heat, chemical gas, and wind speed decide whether your DIY sheet survives the week.
Here are the exact numbers and safe limits I use when floating shipping wrap:
- Maximum sun lifespan: Pull packing wrap off after ten sunny days before flaking starts.
- Minimum film thickness: Skip flimsy 2-mil wrap and choose heavy 6-mil moving wrap instead.
- Bubble height size: Pick small three-sixteenth-inch bubbles so wind cannot flip tall air domes.
- Free chlorine limit: Keep chlorine below 1.5 parts per million or use fresh hose water.
- Maximum pool width: Limit DIY wrap to pools under ten feet wide for easy handling.
| Size / Scenario | Exact Amount | How Often |
|---|---|---|
| Safe sun exposure | Ten days maximum | Trash before flaking starts |
| Ideal bubble width | 3/16-inch small bubbles | Check before cutting roll |
| Sheet overlap margin | Four inches wide | Press flat every evening |
| Maximum wind speed | Under 10 mph gusts | Remove before storms hit |
| Skimmer basket check | Twice every day | Clear loose plastic bits |
Exact Cost and Heat Numbers From My Side-by-Side Comparison
Buying new shipping wrap to cover a full pool costs more per year than real covers. Packing rolls only save money when you already have leftover moving wrap in your shed.
I priced covering a twelve-by-twenty-four-foot pool with hardware store rolls versus a 12-mil solar blanket. Because shipping wrap comes in narrow two-foot strips, you need six passes plus tape.
- DIY packing wrap cost: Three large moving rolls cost $65 and died in two weeks.
- Real 12-mil cover cost: One real pool sheet cost $110 and lasted four full summers.
- Daytime heat gain: Real pool film heated water three degrees warmer than thin shipping wrap.
- Filter cleanup time: DIY wrap cost me two hours of picking plastic out of baskets.
My Step-by-Step Routine to Make a DIY Bubble Wrap Cover
If you want to warm a small kiddie pool this weekend, build a one-piece sheet cleanly. Follow my three-step method to trim, seal, and float packing wrap without sticky glue mess.
Skip standard gray duct tape from your kitchen drawer when building a water cover. Pool water turns cloth duct tape into slimy gray strings that stain vinyl walls fast.
1. Cut Strips to Fit Inside the Pool Rim
Trim your bubble wrap strips one inch shorter than the inner wall to block wind. Hanging light packing plastic over the top rail lets breezes flip the sheet onto grass.
- Measure the water width across the center of your small pool with a tape measure.
- Unroll your shipping wrap on clean grass with the bumpy side facing the ground.
- Cut each strip with sharp scissors so it floats flat inside the water edge.
2. Join the Seams With Clear Waterproof Repair Tape
Use wide greenhouse repair tape or clear vinyl patch tape to lock narrow rows together. You can also fuse the plastic edges using a warm clothes iron and parchment paper.
- Overlap two strips of wrap by four inches along the long flat factory edge.
- Wipe both plastic edges dry with a clean towel so the tape bonds tight.
- Press three-inch clear greenhouse tape along both the top and bottom of each seam.
3. Float Bubbles Down and Weight the Windy Corners
Lay the sheet with air bubbles facing down into the water so surface tension grips it. Because packing wrap weighs very little, afternoon breezes will try to lift the dry corners.
- Set the joined sheet gently on the water with the smooth flat side facing up.
- Push your hand across the top to burp trapped air pockets out to the walls.
- Rest a smooth plastic milk jug half-filled with water on the windy corner edge.
| Step | Time Needed | Key Shortcut |
|---|---|---|
| Measure and cut strips | Ten minutes | Cut one inch inside wall |
| Tape four-inch overlap seams | Fifteen minutes | Use clear UV greenhouse tape |
| Float sheet bubbles-down | Two minutes | Wet the bubbles before laying |
| Pinch-check bubbles for wear | Thirty seconds daily | Squeeze three corner bubbles daily |
My Iron-Seam Trick: Overlap two wrap edges by three inches between sheets of parchment paper. Glide a warm iron over the paper for three seconds to fuse them.
Rookie Mistakes I Made Testing Packing Wrap on Water
My worst mistakes were running the filter pump unattended and testing silver foil insulation wrap. Both blunders cost me hours of sweaty cleanup and zero extra degrees of water warmth.
During my test on our main pool, I left the skimmer pump running overnight. A loose two-foot strip of packing wrap tore free and clogged the skimmer throat tight.
Here are the four mistakes I made and how you can avoid them completely:
- Running the pump with thin wrap on: Suction pulls light plastic right into the pipe. Always turn off your pump while floating light DIY wrap.
- Testing silver foil bubble wrap: The shiny metal layer bounced ninety percent of sunlight away. My water actually stayed four degrees colder than an uncovered pool.
- Using brown box packing tape: Wet glue dissolved into sticky brown strings across the water. Only use clear vinyl patch tape or heat-fused seams.
- Waiting until bubbles popped to remove it: Once ten bubbles flake off, hundreds follow within hours. Toss the wrap the moment the clear film turns cloudy.
| My Early Mistake | What Happened | What I Do Now |
|---|---|---|
| Ran pump with thin wrap | Sucked strip into skimmer pipe | Shut pump off with DIY wrap |
| Tried reflective foil wrap | Kept pool four degrees colder | Use clear translucent wrap only |
| Taped seams with duct tape | Left sticky gray glue rings | Heat-seal seams with parchment paper |
| Left wrap on three weeks | Clogged filter with plastic flakes | Trash wrap after ten sunny days |
Daily Pinch Test: Pinch three corner bubbles between your fingers before swimming each morning. If the plastic crinkles loudly or splits open, trash the whole sheet right away.
Better Alternatives and Cheap Swaps That Last Years
Instead of fighting flimsy shipping wrap, buy budget pool heaters that never shed plastic flakes. Even a twenty-dollar upgrade beats picking melted bubble skins out of your skimmer basket.
After retiring my garage bubble wrap test, I tried four cheap ways to warm water. Each option below gave me comfortable swim temps without the two-week flaking mess.
- Buy an 8-mil budget solar cover ($35 to $60): It costs about the same as three moving rolls. Plus, UV stabilizers keep it intact for two full summers.
- Float magnetic solar pool rings ($25 each): Five-foot UV vinyl circles cover small pools fast and hang flat on a garage nail.
- Pour in liquid solar blanket ($18 a bottle): A weekly dose forms a safe surface film that cuts night heat loss in half.
- Lay black contractor trash bags on kiddie pools ($5): Float two heavy black bags flat in the sun for three hours before toddlers swim.
| Warning Sign | Real Cause | My 2-Minute Fix |
|---|---|---|
| Clear flakes floating on top | UV rays rotted thin bubbles | Skim with fine mesh net now |
| Wrap bunches at one side | Wind blowing under tall edges | Trim edges inside the pool wall |
| Pump making loud sucking noise | Wrap pulled into skimmer mouth | Kill power and clear basket fast |
| Sticky line on pool wall | Tape glue melted in sun | Wipe tile with rubbing alcohol pad |
FAQs for can bubble wrap be used as solar pool cover
Can bubble wrap be used as solar pool cover on an inground pool?
Avoid using packing bubble wrap on large inground pools. Thin shipping film breaks down in chlorine and clogs expensive pool filters within two weeks.
How much does packing bubble wrap heat a small kiddie pool?
Standard packing bubble wrap warms a small kiddie pool by 5 to 7 degrees. It traps daytime sun heat and stops cool night wind from stealing warmth.
What is the difference between bubble wrap and a solar cover?
A real solar cover is four times thicker and contains UV stabilizers. Standard packing wrap measures only 3 mils thick and melts fast in harsh sunlight.
Does silver foil bubble wrap work to heat swimming pool water?
No, reflective silver foil bubble wrap keeps your pool water colder. The shiny metal surface bounces warm sunlight away before it heats the water.
Which way do the bubbles go when floating bubble wrap on water?
Always place the air bubbles facing down directly into the pool water. The wet pockets grip the surface against wind and transfer sun warmth downward.
How long before packing bubble wrap disintegrates in a pool?
Packing bubble wrap starts flaking apart after 10 to 14 days in the sun. Pool chlorine and UV rays make the thin plastic brittle within two weeks.
My Final Verdict on Using Packing Bubble Wrap on Your Pool
Packing bubble wrap warms small kiddie pools for a weekend, but ruins filtered swimming pools. While it adds six degrees fast, sun and chlorine shred thin plastic within two weeks.
Walk into your garage right now for a quick five-minute wrap check before starting. Pinch the bubbles to verify they are small, skip any shiny silver foil rolls, and order a real 8-mil solar blanket if your pool has a pump.






Leave a Reply